The processing consists of three steps. Use the gel of the appropriate color for each step!
Step 1 (10 shots): Use a rifle brush to apply red gel into the inner barrel surface. Apply the gel to the bullet surface protruding out of the cartridge. Shoot once. Repeat points 1 and 2 and shoot again no less than nine times.
Step 2 (10 shots): Apply yellow gel into inner barrel bore of riffle and shoot not less than ten times.
Step 3 (10 shots): Apply green gel and shoot not less than ten times.
Notes! Process new barrels with the green gel and make 10 shots. For preventive maintenance of restored barrels it is recommended once a year to make ten shots using green gel or make 10 shots using same gel after every 1000 shots.
Increases accuracy of hits up to 80% on 100 m target; increases flatness of shots; increases wear-out resistance and barrel endurance up to 10 times; maximum destruction potential for the given type of ammunition; restores and protects the barrel bore from wear-out; restores geometry of the barrel bore (full obturation).